Eventide H90 Harmonizer, User Manual

Page: 46 / 176

Set the mix to 50%.
Bypass the external digital effect or adjust any mix knob so you only hear the dry signal.
Adjust latency from 0 samples until the signal is silent or as quiet as possible.
Disengage the polarity invert.

Tip
When using Insert or Dual routing, press Quick Knob 1 to swap Presets A and B.
6.2.2. Dual Routing
Dual Routing allows you to route two processing paths within your H90. This can be used to process two
instruments separately through two different Presets, or to connect to an ampli
fi er in a Pre/Post
con fi guration using one Preset in your preamp section and one Preset in your amp’s effects return.

Note
Programs using Dual Routing will display in the top right corner.
Fig. 6.15
Programs using Dual Routing
Turn Quick Knob 1 to change the routing position for Presets A and B on Paths 1 and 2.
Quick Knob 2 and 3 are non-functional when Routing Mode is in Dual Routing con
fi guration.
Dual Routing enables two separate signal paths:
Path 1: Inputs 1/2 to Outputs 1/2
Path 2: Inputs 3/4 to Outputs 3/4
•
•
•
•
•
•
•
•
•
46
6. EDIT MODES