Eventide H90 Harmonizer, User Manual

Page: 149 / 176

Modulation Level: increases random modulation of reverb tails.
Mid Band Reverb Level: boost/cut of MID reverb (between 300 and 1500 Hz), -100 effectively cuts
all of the mid band reverb.
MangledVerb
We recognize the universe is a chaotic and often violent place, so in the spirit of the yin and yang of it all,
we’re proud to present MangledVerb. Technically, MangledVerb feeds a non-standard stereo reverb into
distortion, but sonically, it can range from the light friction of a bow scraping a cello string to obnoxious
mayhem. Judicious use of the Wobble and Overdrive is approved, and try setting small ranges for Size
and Decay for some surprising sounds.
Fig. 3
MangledVerb’s signal
fl
ow diagram
Mix: Wet/dry mix, where 100 is an all wet signal. It has a special nonlinear taper which puts most of
the knob travel in the most usable range. Note: the Mix control is not accounted for in the signal
fl ow diagram.
Decay: Length of reverb decay scaled from 1-100. Less decay will take away reverb attack.
Speci
fi cally, higher values (greater than 70) will impart traditional reverb tails, while lower values
(less than 70) can result in reverse reverb sounds with more build up.
Size: Determines the size of the reverb. To use MangledVerb as a distortion type effect, try setting
this below 15.
Pre Delay: Sets the amount of delay before the reverb section. When tempo mode is off, this range
is from 0 to 1500 milliseconds. When Tempo Sync is set to ON, Pre-Delay is set in beat divisions of
the tempo. The Pre-Delay control affects the Pre-Delay Block in the signal
fl ow diagram.
Low Band Level: Boost/Cut of the low frequencies before the distortion section of the signal path.
Mid Band Level: Boost/Cut of the middle frequencies before the distortion section of the signal
path.
High Band Level: Boost/Cut of the high frequencies before the distortion section of the signal path.
Softclip/Overdrive Type: Use this control to choose from two types of distortions (soft-clipping and
overdrive) and set their gain/drive amount. The
fi rst half of the knob controls the Softclip gain level
from 1 to 100. Passing 100 in Softclip switches the distortion type to Overdrive with a gain/drive
•
•
•
•
•
•
•
•
•
•
10. ALGORITHM GUIDE
149