23
22
PLAC
E
ATARMPIT
IMPORTANT
When installing this child restraint with LATCH or the
vehicle seat belt, always use the top anchorage strap
(tether), if a tether anchor is available.
Tether
Strap
Child Requirements
Weight:
10 to 22.6 kg (22 to 50 lbs)
Height:
71 to 127 cm (28 to 50 in)
and tops of the child’s ears are at
or below the top of the
child restraint headrest
•
Age:
At least 2 years old
Harness straps are
at, or slightly above,
the child’s shoulders.
Forward-facing
Belt Path
Lower Anchor
Connector
Assembly
IMPORTANT:
Once your child
exceeds any of the size
requirements for
forward-facing use above, you
MUST
discontinue use of this child restraint with its internal harness
and begin using it as a
belt-positioning booster seat, if
possible. If your child
exceeds any of the size requirements for
forward-facing use above and is less than 4 years old, however,
you
MUST
discontinue use of this child restraint.
Using the Internal
5-pt Harness
1. Disconnect tether
hook and lower
anchor connectors
from the back of the
child restraint.
Tether Strap
2. Place the child restraint in position.
Set child restraint on vehicle seat in forward-facing
position. Lay the tether strap over the back of the
vehicle seat.
To avoid a strangulation hazard, you
MUST
store the
unused lower anchor connector assembly, with all slack
removed, in storage area on the back of the seat
(p.
). Roll or fold excess lower anchor connector
strap and secure with a rubber band to prevent serious
injury to vehicle occupants.
WARNING
LATCH is a system for attaching the child restraint
to your vehicle seat. It is to be used in place of your
vehicle’s seat belts and can be used in vehicles with
LATCH anchors.
DO NOT
install this child restraint with
the vehicle seat belts AND LATCH (Your vehicle owner’s
manual may refer to this system as ISOFIX, Universal
Anchorage System (UAS), or Lower Universal Anchorage
System.)
5
-p
t Harne
ss
5-pt Installation with Lower Anchor
Connectors
