39
38
Remove the lower anchor connector strap
E
from the
rear-facing position (front openings).
3
E
4
Insert the ends of the lower anchor connector strap
E
in the forward-facing belt path openings, as shown
(back openings). Note: Make sure the adjustment
buckle
F
enters the opening on the correct side of the
child restraint, as shown.
E
F
After the lower anchor connector strap
E
has been
correctly inserted, it will appear as shown above.
Note: Make sure the adjustment buckle
F
is on the
correct side of the child restraint, as shown.
E
F
7
Using your full weight push
the child restraint firmly into
the vehicle seat, while pulling
up on the lower anchor
connector strap to tighten.
The lower anchor connector
strap must be as tight as
possible. If you can move
the child restraint more than
25 mm (1 in.) side to side
or front to back at the belt
path
H
, the lower anchor
connector strap is not tight
enough. You will need to try
again, find another location
H
Refer to your vehicle owner’s manual to locate the
lower anchor bars on your vehicle seat.
Attach the left hook
A
, or clip
B
, to the left anchor
bar
G
, and the right hook to the right anchor bar.
DOUBLE CHECK
that each lower anchor connector
hook or clip is fully engaged by pulling hard on the
lower anchor connector strap.
6
IMPORTANT: Make sure both lower anchor Quick Connectors
are facing upward and the straps are not twisted.
Correct
Incorrect
for your child restraint, or install with the vehicle
seat belt (page 30). To remove the lower anchor
connector strap, go to page 45.
G
A
B
G
5
For
ward-facing
