· INSTALLATION INSTRUCTIONS ·
98-505-.
MultiCompactAdapter Standard
with data bus option
2 Circuit ( 120V )
Tracks and Adaptors
www.EUTRAC.com
2~
07.09.2017
# 427806
MT 6.077/1
1/5
Page
TRACK LIGHTING FITTING
44WB
INSTALLATION INSTRUCTION
·
READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE
INSTALLING THE EUTRAC TRACK SYSTEMS.
· Materials used for ceiling fixation should conform to the relevant
building regulations.
·
SAVE THESE INSTRUCTIONS AND REFER TO THEM WHEN
ADDITIONS TO OR CHANGES IN THE TRACK CONFIGURATION
ARE MADE.
· Track is only to be used with other electrical fittings identified for use
with the EUTRAC track system 230/233 .
· To be installed by trained personnel only ( electricians ).
· It is the responsibility of the installer to ensure the electrical,
mechanical and thermal compatibility of the track system
and the fittings.
· This track system is not intended for use with a power supply cord
or convenience receptable adaptor.
· The Installation and operation of this track system are subject to
national safety regulations.
The manufacturer is not liable for damage caused by improper
use or installation.
If any track system components is subsequently modified,
the person responsible for the modification shall be considered
as manufacturer.
· It is essential to cover the ends of the track with end covers or
protective caps.
·
READ ALL INSTRUCTIONS.
· Do not install this track in damp or wet locations ( IP20 , 45°C max.).
· ( For track lighting systems other than 120V, two circuit )
Do not connect the track to more than the branch circuit unless
the track is constructed so that it can be used with more than one
branch circuit.
Check with a qualified electrician. Although the track lighting
system may seem to operate appropriately, a dangerous overload of
the neutral may occur and result in a risk of fire.
· Do not install any part of a track system less 5 ft. above the floor.
·
SAVE THESE INSTRUCTIONS.
· Disconnect electrical power before adding to or changing the
configuration of the track.
· Do not attempt to energize anything other than lighting track
fixtures on the track.
In order to reduce the risk of fire and electrical shock, do not attempt
to connect power tools, extension cords, appliances and the like to
the track.
· Do not slide light fixtures along track when re-locating.
Always remove fixture/adapter from track.
Re-install in new location making sure to properly secured
adapter back in track.
· Do not install any fixture assembly closer than 6 in. from
any curtain or similar combustible material.
IMPORTANT SAFETY INSTRUCTIONS