12
simultaneous to get PC port 9 (10,11,12,13,14,15,16) respectively.
For example: The user would like to switch console port to PC port 12. He can press
“ Shift “ button and port 4 button simultaneously. The port LED of PC port 12 is lit when the
console is switched to PC port 12.
Reset Button (
(“ Bank ” button) and
(“ PC 8 ” button )
):
To press both “PC 8 ” button and “ Bank ” button of master bank simultaneously can reset
KVM switch. This reset action will not only return KVM switch back to initial state --- Check
the password, but also re-check all of slave banks which connected to mast KVM Switch.
If you add a new KVM Switch as a slave bank, please use reset button of master KVM
switch to automatically assign a new ID to it. You can view this new slave bank go through
OSD menu. The PC ports of KVM Switch does not be reset by reset command.
16 port Rack Mount USB KVM Switch (16 Ports)
PC port LED Indication :
There are two LEDs--- Power LED
(The LED is marked by “ P “)
and Link LED
(The LED
is marked by “ O “ )
accompanied with each PC port.
When you select one of sixteen PC ports and this PC is shut down or this PC port is
disconnected to the PC, the selected power port LED is off (But, if this PC is PC99 type, the
selected power port LED is lit) and the Link LED is flash. When you select one of sixteen
PCs ports and this PC is powered on, the selected port Link LED is lit.
Note: If there are one of rack mount of KVM switches you used is 16 port USB KVM switch,
please put 16 port USB KVM switch on the 1
st
bank ( or say Master bank). It is based on 16
port USB KVM switch supports 16 port LEDs display on the front panel. Otherwise, 4 port
or 8 port USB KVM switch is allocated at 1
st
bank and there is a 16 port USB KVM switch
chained to the slave bank, the master bank ( or say 1
st
bank ) is unable to show the PC port
LEDs ( from port 9 to 16 ) of 16 port USB KVM switch completely.
7-Segment BANK LED Indication
When you would like to view the next bank KVM switch, please press “ BANK “ push button
cyclically to the destination bank. The bank LED will be changed from bank 1 to the
maximum daisy chain level and then to press “ BANK “ push button once back to the bank
1.
Bank 1 Bank 2 Bank 3 MAX BANK
Keyboard Hot Key Commands:
You can also conveniently command KVM switch by switching ports through simple key
sequences. To send commands to KVM switch,
the “SCROLL LOCK” key must be
pressed twice within 2 seconds.
You will hear a beep for confirmation and the keyboard
is in hot key mode. If you have not pressed any key in hot key mode within 2 seconds (It
means to key in any key follows up “Scroll Lock” “Scroll Lock” key ), the keyboard will back
to under Operation System control state.
