EN
24
the catch shut again after inserting the
mop roller.
•
The
suction nozzle
sucks up the dirty
water and also acts as splash protec-
tion at the same time. It is attached
on top of the wet cleaning nozzle.
To fix or release it, slide its catch (
25
)
towards the fresh water tank.
•
The
fresh water tank
is secured in the
wet cleaning nozzle on the left and
right in each case with a fastener (
20
).
Flip open the two fasteners and
take out the fresh water tank. After
inserting the fresh water tank, flip the
fasteners up again.
Filling the Fresh Water Tank
Please Note!
■
Never pour any cleaning agent or ad-
ditives into the fresh water tank. This
might damage the device.
L
We recommend that you use pref-
erably distilled water in order to
prevent calcification, particularly if
your tap water is very hard.
1. Take the fresh water tank out of the
wet cleaning nozzle (see the “Wet
Cleaning Nozzle” section).
2. Twist the lid (
18
) a little anticlockwise
and take it off.
3. Pour clean water into the fresh water
tank.
4. Put the lid on and turn it clockwise to
secure it.
5. Insert the fresh water tank into the wet
cleaning nozzle.
Use
Please Note!
■
Never turn the device upside down
when there is water in the tanks.
■
If water gets into the dust container,
immediately switch off
and clean the
device (see the “Cleaning the Device”
chapter – “Dust Container”).
■
Note the MAX marking on the dirty
water tank and empty it as soon as it
is reached (see the “Cleaning the De-
vice” chapter – “Dirty Water Tank”).
1. Vacuum or sweep the floor to remove
coarse dirt.
2. Assemble the wet cleaner (see the
“Assembling” and “Wet Cleaning
Nozzle” sections).
3. Fill the fresh water tank with water
(see the “Filling the Fresh Water
Tank” section).
4. To release the parking position of the
device, fix the wet cleaning nozzle
with the foot, hold the main unit firmly
by the handle (
33
) and move it back
towards the floor.
5. Press the
ON
/
OFF
button (
31
)
to switch on the device. The mop
roller begins to rotate. The operating
lamps (
48
) switch on.
L
If only one operating lamp is
flashing, the battery is weak
and needs to be charged (see
the “Charging Up the Battery”
chapter).
6. Use the button (
26
) to switch the
water nozzles (
21
) on (and off).
7. If necessary, switch the UV-C light (
22
)
on and off with the button (
19
).
8. Guide the wet cleaning nozzle over
the surface to be cleaned. This is wet
cleaned with the mop roller. The dirty
water is sucked up and collected in
the dirty water tank.
04350_Inlay_de-en-fr-nl_A5_V1_1.indb 24
04350_Inlay_de-en-fr-nl_A5_V1_1.indb 24
07.05.2020 15:50:45
07.05.2020 15:50:45
