100/180 MM GRAPHICS RECORDER: USER GUIDE
HA261742
Issue 16 Nov 04
User Guide
Page 84
4.3.8 MESSAGES (Cont.)
Replace {n} with (Cont.)
Specified Descriptor, Specified Value, Specified Alarm data: Produces a further field ‘{n} source’,
described below.
Batch Status: Causes the status ('Active' or 'Inactive') of the current batch to be embedded. See
Section 1 of the Options manual for Batch details.
Batch Field data: Allows a selected batch field to be included in the message. If a batch is not
running at the time the message is triggered, the Batch field data is replaced by '?????'. See Section 1
of the Options manual for Batch details.
Note: Group number must be entered if the batch is configured for Group mode.
Instrument Name: Allows the Instrument Name (as entered in Configuration/Instrument - section
4.3.1) to be included in the message.
Instrument Number: Causes the instrument number (Network/Address - Section 4.5.1) to be embed-
ded.
Config Revision: Embeds the Config File Version number (System/About - section 4.6.5) in the
message
{n} source
This field appears only if the previous field (Replace {n} with) is selected as ‘Specified Descriptor’,
‘Specified Value’ or 'Specified alarm data'. The associated picklist(s) allow a specific point, and a
specific alarm (if appropriate) to be selected. It is thus possible to configure, say alarm 1 on channel 2,
to produce a message giving the descriptor and/or value of, say, totaliser 1.
Notes:
1.
n = 1 to 9
2.
The example below is intended to clarify message entry techniques.
