100/180 MM GRAPHICS RECORDER: USER GUIDE
User Guide
Page 27
HA261742
Issue 16 Nov 04
Touch Current
access level key
Group name
11:52:59
16/05/00
11:52:04
16-May-00
11:49:24
16-May-00
11:46:44
16-May-00
16/05/00 11:47:51 Alarms(s) on 3(1)
16/05/00 11:51:33 Alarms(s) off 3(1)
99%
Logged out
Login
Select the required access level and enter the password if
required.
Cancel
User
Logged out
Operator
Engineer
Service
Logged out
Touch 'logged out'
area...
...then touch access
level required.
Touch the password window when it appears, and enter the password.
The Engineer level password is '10' when the unit is despatched from
the factory (but see note 1 below). Passwords can be edited in
'Security' as described in section 4.4.1.
The screen reverts to the home page, with the new access level dis-
played in the 'Current access level' key
0.00
100.00
Channel 1
73.98V
20.00
40.00
60.00
80.00
2
1
3
3.3.1 Access to Configuration
1
As shown in figure 3.3.1a, once the recorder has initialised, touch the current access level key
2
Touch the 'Logged out' field and then touch 'Engineer' from the resulting picklist.
3
Touch the blank Password area to call the keyboard display (see figure 3.3.1b).
4
Touch <Numeric><1><0><OK> (note 1) to enter the password '10'. The screen reverts to the 'Home' page.
5
Operation of the Root key followed by a touch on the Operator key calls the top level page allowing access to the
Archive, Save/Restore, Config, Security, Network and System areas described in section 4 below.
Figure 3.3.1a Access to configuration
Notes:
1.
For units fitted with software versions 3.1 onwards, AND which have the Auditor Pack Option enabled,
the default Engineer and Operator passwords are both '100'.
2.
Figure 3.3.1a shows 'Login by user list' which is the default method. If the Audit pack and/or Security
management option is fitted, an alternative 'Login by user ID' procedure is possible. See
(Management) for details.
