100 MM GRAPHICS RECORDER: USER GUIDE
HA027271
Issue 12 Mar 04
User Guide
Page 80
4.5 NETWORK CONFIGURATION
Notes
1.
The Network key appears only if the Ethernet option is fitted
2.
This manual does not describe network setup in detail, as each network is different. In mosy cases, the
help of the network administrator or supervisor will be required, for example, in the allocation of valid
addresses and passwords.
Operating the Network key calls a selection box to the display, allowing ‘Address’ or ‘Name’ to be selected for con-
figuration.
4.5.1 Address
Figure 4.5.1 shows the address menu fields.
Figure 4.5.1 Network addressing
INSTRUMENT NUMBER/MAC ADDRESS
Unique numbers set up during manufacture to identify the recorder to a remote host, or to the recorder manufacturer/
distributor, in case of query.
IP ADDRESS LOOKUP
This field allows an address to be entered for the recorder. This can be done either by manually entering an address
(IP address field - below), or the network service BootP can be used to assign an IP address to the recorder.
BOOTP TIMEOUT
This is the maximum time the recorder will wait, at power-up, for a response from the BootP server. If no response is
received within this time, the IP address, Subnet mask and Default gateway are all set to, or remain at 0.0.0.0
IP ADDRESS
Allows manual entry of the recorder’s internet protocol (IP) address only if ‘Specify an IP address’ is selected in the
‘IP address lookup’ picklist above.
Mac address
IP address lookup
IP address
Subnet mask
Default gateway
192.168.111.222
255.255.255.0
0.0.0.0
Instrument number
1867
08:00:48:80:07:4B
Obtain from a BootP Server
Apply Discard
Fig 4.5.2
Select 'specify an IP address' or
'Obtain from a BootP Server'
BootP timeout
1
s
Does not appear for 'Specify IP address'
Address
Name
Archive
System
Save/R.. Config
Security Network
SNTP enable
SNTP server
149.121.129.205
