Eurotech PCN-1001, User Manual

Page: 99 / 118

Note
for mounting the front panel with angles from 20 up to 45 PCN-1001 User manual
99
PCN-1001_UserMan_En_4.0
Note for mounting the front panel with angles from 20°
up to 45°
Please contact Eurotech to use this configuration in order to properly configure the software parameters of the
PCN-1001.
To use front panel angles between 20° and 45°, it is recommended to mount the PCN-1001 Extender to better
protect the rear connections. It is also recommended to install any cabling before mounting the extender, this will
give easier access to M1 and M2.
Use the two M3 x 6 hexagonal head screws (and the two split washers) provided to fix it to the PCN-1001. A
hexagonal 2 mm (3/32”) key/driver is required.
This is the procedure for mounting the PCN-1001 Extender:
1. Place the Extender onto the rear of the PCN-1001; ensure that the two locating tabs ( A and B ) are correctly
aligned
2. Ensure that the holes on the Extender and on the PCN-1001 are correctly aligned
3. Insert the two washers and the two M3 screws into the holes and firmly tighten them.
IMPORTANT NOTE!
Once the PCN-1001 is installed, the angle of the front panel cannot be modified and the rear
connectors cannot be accessed without removing the entire device from the ceiling.
1
2
3
Extender
A
B
Locating tab
M3 screw