Eurotech PCN-1001, User Manual

Page: 71 / 118

Know
WinClient PCN-1001 User manual
71
PCN-1001_UserMan_En_4.0
The “Wide-Gate” tab
When you need to monitor gates wider than 120 cm the “Wide-Gate” is an algorithm that has been developed in
order to properly configure the necessary PCN-1001 devices.
Setting up the PCN-1001 devices for the Wide-Gate configuration
1. Connect properly all the PCN-1001 devices as described in the paragraph Number of PCN-1001 devices
required on page 27
2. Connect your Host PC via the USB port (located under the service plate) to the Master PCN-1001 (the one
directly connected to the Control Unit)
a. Launch the WinClient utility and Click “Scan”
b. Select the IP address of the PCN-1001. Click “Connect”
c. Select the “Controls” Tab. Click “Restore Factory Settings”
d. Click “Yes” when the “Warning” message will appear.
If you do not perform a restore before configuring the “Wide-gate” mode you may receive the
following error:
e. Select the “Connection” Tab and click “Disconnect”
3. Connect your Host PC via the USB port to the 1
st
Slave PCN-1001
a. Click “Scan”
b. Select the IP address of the PCN-1001 and click “Connect”
c. Select the “Controls” Tab
d. Click “Restore Factory Settings”
e. Click “Yes” when the “Warning” message will appear
f. Select the “Connection” Tab and click “Disconnect”
4. Move to next Slave PCN-1001 and repeat the above step 3 for all Slaves
5. Connect your Host PC via the USB port to the Master PCN-1001
a. Click “Scan”
b. Select the IP address of the PCN-1001 and click “Connect”
c. Select the “Wide-Gate” Tab
d. Insert the quantity of counters connected (i.e.: 2)