TLE TUBULAR LATCH
FITTING INSTRUCTIONS
+44 1228 511030
Carlisle Brass Ltd, Parkhouse Road, Carlisle, CA3 0JU
[email protected]
www.carlislebrass.com
FITCB0178 | Revision A
We recommend consulting a professional if you are unfamiliar with installing hardware fixtures.
Page 1 of 2
Carlisle Brass Ltd
Parkhouse Road,
Carlisle,
CA3 0JU
2812 - CPR - AG5228
21
EN 12209: 2003 / AC 2005
Classification
1121
Lock Information - Accreditation, Performance & Suitability for use on Fire Doors
Item
CE Ref
Declaration
of
Performance
EN 12209 : 2003 classification
Intumescent
Requirements
FD30 & FD60
Timber Doors
BTL1
AG5228
CBB213
NPD
A
7
1
0
C
-
B
0
NPD
0
0.8mm
Intercalated
Graphite
intumescent sheet
BTL2
NPD
A
7
1
0
C
-
B
0
NPD
0
BTL3
NPD
A
7
1
0
C
-
B
0
NPD
0
BTL4
NPD
A
7
1
0
C
-
B
0
NPD
0
BTL25
NPD
A
7
1
0
C
-
B
0
NPD
0
BTL30
NPD
A
7
1
0
C
-
B
0
NPD
0
Tools required: Drill & 25.4mm (1”) drill bit, Mallet, Chisel, Posidrive
Screwdriver, Pencil, Masking Tape
The mortice must always be aligned horizontally and vertically
in order for all relevant components to operate as intended.
Misalignment of any single component can lead to the breakdown of
complete door set operation.
It is recommended to pilot all fixing screw locations prior to final
fitting to prevent excess strain on the fixings.
Using a pencil, mark the door edge for the height and width of the
mortice, and also for the forend. Use these markings as your visual
guide to ensure you cut the mortice to the correct dimensions.
Using a 1” drillbit, drill the mortice accordingly, ensuring any
shavings or swarf are removed and the mortice is smooth.
Note: Use tape to mark the correct depth of the drill bit. The required
depth is the latch/deadbolt body Fixed Loose Face
Plate.
Insert latch body into mortice and draw around the faceplate. Chisel
out to the required depth (which will include the loose faceplate).
Preparation And Installation