LAMPO Multifunction Unit
ST
D
MIN
MA
X
2.5 HANDLING THE MACHINE
Unloading, transport and handling
Upon arrival, the parts of the machine, protected only by weather cover, must be handled with the maximum care, carefully following any indications given on
them or those contained in this Instruction Manual.
If during lifting the slings come into contact with parts of the machine, it is necessary to intervene, interposing protective materials between the
parts, to avoid damage to the machine and the wearing of the sling (highly dangerous). For machine lifting and handling, pay attention to anchor the
lifting means at the points indicated by these symbols
Excessive or inappropriate speed
The carriage could swerve and cause the machine overturning.
Respect the speed regulations of your country.
Worn tyres / Unsuitable tyre pressure
Tyres could burst when driving and cause instability. The braking distance is longer. The carriage might be unstable and detach when driving.
•
Check the tyres on a regular basis
•
Periodically check pressure, depth of the profile and condition of the tyres (see point 5.5.1)
Loss of bolts
The carriage could swerve and detach from the vehicle.
Tighten the wheel nuts again after the first 50 km and after each wheel replacement.
Check that wheel nuts are properly secured (see maintenance table).
Use on the road
Check in point 1.1 of this manual if the carriage is approved for use on the road
15
Summary of Contents for LAMPO GREEN
Page 2: ......
