INSTALLATION AND PREPARATIONS FOR USE
14
Changing the gas inlet:
For some countries, the gas inlet type can be different for NG/LPG gases. In such a case, remove the
current connection components and nuts (if any) and connect the new gas supply accordingly. In all
conditions, all components used in gas connections should be approved by local and/or
international authorities. In all gas connections, refer to the “Assembly of gas supply and leakage
check” clause explained before.
Figure 13
Figure 14
Figure 12
Valve with flame failure device
Valve with flame failure device
Valve without flame failure device
Bypass screw
Bypass screw
Bypass screw
(Inside the hole)
The position the bypass screw must be loosened for conversion from LPG to NG. For conversion
from NG to LPG, the same screw must be fastened. Make sure that the appliance is unpluged from
the electric mains and the gas supply is open.
Before making a connection, check that:
· The mains voltage is the same as that quoted on the rating plate which is situated at the back of your hob.
· The circuit can support the appliance load (see the rating plate).
· The power supply has an earth connection, which complies with the provisions of current regulations and
is in good working order.
· The fused switch is easily accessible once the hob has been installed.
If there is no dedicated hob circuit and fused switch, they must be installed by a qualified electrician before
the hob is connected.
3.5
Electrical Connection Of Your Hob