41907172_V_1_1.DOC
14/31
INSTALLATION
Installing/Replacing the lamps
DANGER TO LIFE!
Only install the lamps with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
CAUTION!
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need four 230 V/750 W R-7-s or 230 V/1000 W R-7-s pole-burners.
Procedure:
Step 1:
Remove the color-filter-frame.
Step 2:
Unlock the protective grid and open it.
Step 3:
If replacing the lamp, remove the old pole-burner from the lamp socket.
Step 4:
Insert the new pole-burner into the lamp socket.
Step 5:
Close the protective grid and close the lock.
Do not operate this device with opened protective grid!
Overhead rigging
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
