00026026.DOC, Version 3.0
8/9
installation material and the mirror ball. If you lack these qualifications, do not attempt the installation
yourself, but instead use a professional structural rigger. Improper installation can result in bodily injury
and.or damage to property.
The mirrorball has to be installed out of the reach of people.
Caution:
Mirrorballs may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the mirrorball!
Before rigging make sure that the installation area has to hold a minimum of 10 kg point load.
For the mirror ball 10 and 15 cm, only the EUROLITE MD-1015 rotary motor with power plug, No. 50301150
or EUROLITE MD-1030 rotary motor with power plug, No. 50301205 or a safe technically equivalent motor
has to be used.
The mirrorball has to be connected via an appropriate installation (see above) with the motor. We
recommend to use the Chain for Mirrorballs up to 40 cm, 33 cm, No. 50301600 or Chain for Mirrorballs up to
40 cm, 100 cm, No. 50301605.
The installation material must never include abrading material e. g. steel cables in order to avoid
material wearing.
The length of the chain must never exceed 100 cm.
Install the mirrorball chain with the screw-on chain link at the installation eyelet of the mirrorball and tighten
the fixation screw.
Insert the mirrorball chain with the mirrorball in the screw-on chain link and tighten the fixation screw.
Make sure that the rotation of the mirrorball is never slowed down or stopped by decoration material etc.
Make sure that no side forces can impact on the installation.
Please check in regular intervals, if the installation material (e. g. shackles, screw-on carabines or screw-on
chain links) or chain links have been deformed. Uninstall the mirrorball immediately in such a case.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
