EuroLite LED WMB-830 RGB Bar, User Manual

Page: 21 / 28

51930310_V_1_0.DOC 21/28
Addressing
Define the DMX starting address via the control board.
To define the starting address press MODE until the display indicates
"
A001 ". The appropriate LEDs light up.
Set the address via the UP- and DOWN buttons.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the EUROLITE LED-bar starts running and indicates the last
operating mode on the display.
Stand Alone-Mode
1. Chaser
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
LED WMB-bar, you can select up to 16 different chasers.
Selecting a chaser
Press the MODE button until the appropriate LED (AUTO) lights up on the
display.
Now, select the desired chaser (
Pr01 – Pr16 ) via the UP or DOWN buttons.
Press the MENU button, to adjust the speed ( S ) between 80ms/step ~ 5s/step
and brightness (
d
) between 0-100%.
Use the UP or DOWN buttons to set the values.