www.eurolite.de
31
Operation without External Control
►
Automatic Mode
In automatic mode, various show programs are available that run at an adjustable speed.
1
Press the button
MODE
so many times until
Aut
is indicated in the display. Confirm with the
ENTER
button.
2
Use the buttons
UP
and
DOWN
to select the desired program mode:
AutP
= flower LEDs,
AutF
=
strobe LEDs,
AutL
= laser or
AutM
for a combination of all light effects. Confirm with the
ENTER
button.
3
Use the buttons
UP
and
DOWN
to select the number of the desired program.
4
Confirm with the
ENTER
button. The display indicates menu item running speed.
5
Use the buttons
UP
and
DOWN
to adjust the running speed of the program from
S 1
(fast) to
S 99
(slow).
6
Confirm with the
ENTER
button.
►
Sound control
Via the microphone, which is integrated in the control unit the light set can perfectly reproduce the 37 show
programs to the rhythm of the music (sufficient bass provided).
1
Press the button
MODE
so many times until
Sou
is indicated in the display. Confirm with the
ENTER
button.
2
Use the buttons
UP
and
DOWN
to select the desired program mode:
SouP
= flower LEDs,
SouF
=
strobe LEDs,
SouL
= laser or
SouM
for a combination of all light effects. Confirm with the
ENTER
button.
3
Use the buttons
UP
and
DOWN
to select the number of the desired program.
4
Confirm with the
ENTER
button.
5
Adjust the microphone sensitivity to the volume of the music with the control
SENSITIVITY
. The LEDs
and the laser will be switched off after 5 seconds if the volume is too low or if there is no sufficient bass
beat.
Interconnecting Several Show Lasers (Master/Slave Operation)
Several show lasers may be interconnected (max. 32). Then all slave units can be synchronized and
controlled with the master unit without the need for a DMX controller.
The units must be set to the
corresponding operating modes.
►
Slave Units
Configure all slave units before connecting the master unit.
1
Press the button
MODE
so many times until
SLA
is indicated in the display.
2
Confirm with the
ENTER
button. The display will indicate
SLAV
and continue to flash until control
signals are being received from the master unit.
3
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX
controller to the DMX input of the master unit.
► Master Unit
Set the master unit to the desired show program (automatic mode or sound-controlled mode). The
interconnected light sets will now operate in sync.