00121843, Version 1.0
23/28
Run time
With the function
“Fhrs“
, you can display the running time of the device.
Press the
DOWN
button so many times until
Fhrs
is indicated in the display. Confirm with the
ENTER
button.
Firmware
With this function you can display the software version of the device.
Press the
DOWN
button so many times until
vEr
is indicated in the display. Confirm with the
ENTER
button.
The current version will appear on the display.
Remote control IR-26
When actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor. In DMX and slave mode, the IR remote control is deactivated.
Button
Function
Stand By
LEDs off
DMX
DMX operation
Show 1-8
Auto program 1-8
Running speed selection with Speed, Speed +/Speed ‒
LED Color
Color selection for the LEDs
LED Random
Random color selection for the LEDs
Laser Color
No function
LED Random
No function
Sound ON
Sound control on
Sound OFF
Sound control off
Speed +
Program running speed up
Speed ‒
Program running speed down
Speed
Medium program running speed
Notes:
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
•
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
