00046984.DOC, Version 1.1
18/20
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control. You can adjust the sensitivity with the rotary-control on the rearpanel.
Automatic
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. In Auto
Mode the chasers are called up automatically in a continuous loop.
To choose Auto Mode, press the MODE button then press the ENTER button to confirm.
The desired speed values can be selected via the UP or DOWN buttons. (from S001 = fast to S100 = slow)
Press the ENTER button to confirm.
MASTER/SLAVE MODE
You can synchronize a maximum of 32 devices.
Choose the device which will serve as Master. Press the MODE button to choose the Sound Control or the
Auto Mode, then press the ENTER button to confirm.
To set the Slave devices press the MODE button to choose DMX Mode, then press the ENTER button to
confirm. Select the starting address via the UP and DOWN buttons, then press the ENTER button to confirm.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED FE-600 RGB DMX will respond to the controller.
Addressing
Press the MODE button until the display shows 512 and press the ENTER button to confirm.
Set the desired address via the UP or DOWN buttons, then press the ENTER button to confirm.
Controlling:
After having addressed the LED FE-600 RGB DMX, you may now start operating it via your lighting
controller.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Channel 1 – Color settings
Value:
Function:
000 – 009
Blackout
010 – 019
Red
020 – 029
Green
030 – 039
Blue
040 – 049
Cyan
050 – 059
Magenta
060 – 069
Yellow
070 – 079
White
080 – 139
Single color chase
140 – 199
Multi color chase
200 – 224
Automatic (fast)
225 – 249
Automatic (slow)
250 – 255
Sound control
