18
•
EN
OPERATING DETERMINATIONS
•
The LED FE-6 is a show laser for generating laser
and LED lighting effects. Control is possible directly
at the unit or via IR remote control.
•
This device is designed for professional use in the
field of event technology, e.g. on stage. It is not
suitable as household lighting.
•
The country-specific safety regulations and
standards for laser operation must be complied
with at all times.
•
This device may be used only by persons with
sufficient physical, sensorial, and intellectual
abilities and having corresponding knowledge and
experience. Other persons may use this device
only if they are supervised or instructed by a
person who is responsible for their safety.
•
This product is only allowed to be operated with an
alternating voltage of 100-240 V, 50/60 Hz and was
designed for indoor use only. The occupation of
the connection cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral N
Yellow/Green Earth
The earth has to be connected! If the device will be
directly connected with the local power supply
network, a disconnection switch with a minimum
opening of 3 mm at every pole has to be included
in the permanent electrical installation. The device
must only be connected with an electric installation
carried out in compliance with the IEC standards.
The electric installation must be equipped with a
Residual Current Device (RCD) with a maximum
fault current of 30 mA.
•
Lighting effects are not designed for permanent
operation. Consistent operation breaks will ensure
that the device will serve you for a long time
without defects.
•
Do not shake the device. Avoid brute force when
installing or operating the device. When choosing
the installation spot, please make sure that the
device is not exposed to extreme heat, moisture or
dust. There should not be any cables lying around.
You endanger your own and the safety of others!
•
This device must never be operated or stockpiled
in surroundings where splash water, rain, moisture
or fog may harm the device. Moisture or very high
humidity can reduce the insulation and lead to
mortal electrical shocks. When using smoke
machines, make sure that the device is never
exposed to the direct smoke jet and is installed in a
distance of 0.5 meters between smoke machine
and device. The room must only be saturated with
an amount of smoke that the visibility will always be
more than 10 meters.
•
This product was designed for indoor use only.
The ambient temperature must always be between
-5° C and +45° C.
•
Keep away from direct insulation and heaters. The
relative humidity must not exceed 50 % with an
ambient temperature of 45° C.
•
Do not expose this product to flammable materials.
•
This device must only be operated in an altitude
between -20 and 2000 m over NN.
•
Never use the device during thunderstorms. Over
voltage could destroy the device. Always
disconnect the device during thunderstorms.
•
Make sure that the installation complies with the
standards and rules that apply in your country, in
particular EN 60598-2-17. The device must be
installed securely and prevented from falling down.
Always secure it with an appropriate safety bond.
•
Make sure that the area below the installation place
is blocked when rigging, derigging or servicing the
fixture.
•
In order to safeguard sufficient ventilation, leave
50 cm of free space around the device. The
housing must never touch surrounding surfaces or
objects.
•
Do not look directly at the light source! Persons
with light-sensitive epilepsy may suffer from
epileptic seizures or fall unconscious.
•
Please consider that unauthorized modifications on
the device are forbidden due to safety reasons!
•
If this device will be operated in any way different to
the one described in this manual, the product may
suffer damages and the guarantee becomes void.
Furthermore, any other operation may lead to
dangers like injuries to the eyes, short-circuit,
burns, electric shock, crash etc.
•
Never remove the serial barcode from the device
as this would make the guarantee void.
