00041772.DOC, Version 1.2
9/10
Please use the original packaging if the device is to be transported. Make sure that you pack the device in
the original state.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, crash etc.
INSTALLATION
DANGER OF FIRE!
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The device can be installed on the wall or ceiling.
Attachment
Before attaching the device, make sure that the installation area can hold a minimum point load of 5 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1:
Unscrew the fixation screws of the outer ring on the housing with the enclosed tool and remove
them with the ring.
Step 2:
On the baseplate, there are the holes for the installation.
Step 3:
Hold the baseplate onto the location where the device is to be installed.
Step 4:
Mark the boreholes with a pen or a suitable tool.
Step 5:
Drill the holes.
Step 6:
Hold the baseplate in the desired position and tighten the screws to fix the luminary.
Step 7:
Replace the outer ring and tighten the screws.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
