00102251.DOCX, Version 1.0
21/24
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the device will respond to the controller.
If you set, for example, the address to channel 6, the device will use the channel 6 to 10 for control.
Please, be sure that you don’t have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain.
If several devices are addressed similarly, they will work synchronically.
Press the MENU button until the display shows “d001.” You can now set the desired address via the UP or
DOWN buttons. Press ENTER to confirm.
After having addressed the device, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, the dot behind the desired starting address will flash. If there is no data
received, the dot will not flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
DMX-protocol
5-channel mode
Channel:
Value:
Function:
1
000 – 255
Red (0 – 100%)
Channel:
Value:
Function:
2
000 – 255
Green (0 – 100%)
Channel:
Value:
Function:
3
000 – 255
Blue (0 – 100%)
Channel:
Value:
Function:
4
000 – 255
Dimmer (0 – 100%)
Channel:
Value:
Function:
5
000 – 000
No function
001 – 005
Sound Control
006 – 010
No function
011 – 255
Strobe (increasing)
Summary of Contents for BigPARty
Page 1: ......