00109633.DOC, Version 1.0
22/24
Channel
Value
Function
5
000 – 255
Dimmer (0 – 100%)
Channel
Value
Function
6
000 – 000
No function
001 – 005
Sound Control
006 – 010
No function
011 – 255
Strobe (increasing)
Remote control
Button
Function
On/off
FULL ON
All LEDs on at full brightness
FADE/GOBO
No function
/-
Brightness up/down
STROBE
Strobe effect (
3 steps with increasing speed). Press any other
button to exit this mode.
COLOR
Color mode
- color selection is via buttons
1-9
- brightness control via
/-
1
Red
2
Green
3
Blue
4
Red + Green
5
Green + Blue
6
Red + Blue
7
White
8
Red + Green + Blue
9
All LEDs on at full brightness
SOUND ON
Sound control
SHOW
Show mode
- Program selection via button
0-4
0
Endless loop show 1-4
1
Show 1
2
Show 2
3
Show 3
4
Show 4
Notes
1
The device must be activated for remote control. For this, under menu item “
d001
”, press the ENTER
button to confirm activation.
2
When actuating a button, always hold the remote control in the direction of the device (sensor inside).
3
The remote control is supplied with a battery inserted. An insulating foil between the battery and the
battery contacts prevents the battery from being discharged during storage. Prior to the first operation
remove the foil from the battery support on the rear side of the remote control. Otherwise operation of
the remote control is not possible.
4
If the range of the remote control decreases (10 meters as a maximum),
replace the battery. For this purpose, on the rear side of the remote control
press the small bar with the groove to the right and at the same time remove
the battery support. For operation, one 3 V button cell type CR 2025 is
required. When inserting, pay attention that the positive pole of the button cell shows upwards in the
support.
Summary of Contents for AKKU Mini PST-10W
Page 1: ......