00113162.DOCX, Version 1.1
20/24
RDM
With this function, you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an
extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is especially useful when
the device is installed in a remote area.
RDM is integrated in the DMX-transmission line without influencing the connections. New DMX-cables are
not necessary. RDM ready and conventional DMX devices can be operated in one DMX line. The RDM
protocol sends own packages in the DMX512 data feed and does not influence conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the (optional) RDM controller being used.
Remote control IR-Remote 2
The device must be activated for remote control. For this, set menu item
IR REMOTE
to
on
. When actuating
a button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Button
Function
Dimming
Buttons
Off
: off;
20 =
20 %;
50 =
50 %;
100 =
100 % - increasing brightness
Strobe
Buttons
Off
: off;
20 =
20 %;
50 =
50 %;
100 =
100 % - increasing speed
D
DMX mode
SA
No function
SL
Slave mode
S
Setting DMX address; via 1, 2, 3, 4, 5, 6, 7, 8, 9 the DMX addresses can be set
For example, to set the DMX starting address
245
via IR remote, please proceed as follows:
Press
S
for setting the DMX address. Press
2
, followed by
4
and
5
.
Notes:
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
•
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
Summary of Contents for 51916252
Page 2: ......
