00138311, Version 1.0
30/44
Unscrew the four fixation screws of the lamp
system and carefully remove the cover from
the housing.
Unscrew the fixation screws of the lamp
holder and remove the lamp holder.
If replacing the lamp, carefully remove the
lamp from the lamp holder, unscrew and
detach the two connection wires from the
lamp base. Keep the old lamp in a protective
container and dispose of properly.
Carefully attach the two connection wires
onto the base of the new lamp and tighten
the screws again.
Insert the new lamp into the lamp holder.
Please make sure that the new lamp is in the
same position as the old lamp before closing
the device.
If necessary, you can manually center the
"hot spot" (the brightest part of the light
beam) by turning the lamp adjustment screw
with a suitable screwdriver (see graphic)
Replace the lamp system in the housing and
tighten the fixation screws.
Replace the projector head cover and tighten
the screws.
Attention
: Please note, the OSRAM SIRIUS HRI 371W
discharge lamp is not a hot-restrike type. You must
wait approximately 10 minutes before you can attempt to strike the lamp once it has been turned off!
Transport safeguards
The device comes with locked transport safeguards in order to avoid damages.
Please note:
All transport safeguards must be unlocked before operating the device!
TILT safeguard:
Slide the stop lever at the side of the projector arm from Lock to Unlock. Now, the projector
head can be freely moved in the Y-direction.
PAN safeguard:
Slide the stop lever at the bottom of the projector arm from
Lock to Unlock. Now, the projector head can be freely moved
in the X-direction.
Before transporting the device, please slide all stop levers from Unlock to Lock.
Lampenjustierung
Lamp adjustment
Lampe
Lamp
Summary of Contents for 51786850
Page 1: ......
Page 2: ...00138311 Version 1 0 2 44...
