Euroflex NZ, Instruction Manual, Page: 16 / 20

16
Maintenance & Cleaning
M
a
in
te
na
nc
e & C
lea
n
in
g
Decal System - Cleaning the Steam Cleaner
The Decal System alerts the user that the Boiler needs to be cleaned/
decalcified. When your steamer has been used for 11.5 hours, the “Decal
System” button light will flash. Let the unit cool, remove the Water Release
Cap (found underneath the Steam Cleaner) to empty the water, and
clean the Boiler.
• Fill the Boiler with HOT water, shake several times and empty out the
water in a sink. Repeat several times to ensure that the Boiler is flushed
of any calcium or mineral deposits. Wipe the Steam Cleaner with a
damp cloth and dry.
• In areas with very hard water, use a Hard Water Mineral Remover
(found in most hardware or small appliance stores), and follow the
manufacturer’s instructions.
• Once cleaning is complete, replace Water Release Cap.
• To reset the timer and switch off the Decal System lamp, push the reset
button and hold for 5 seconds.
The Water Release Cap should NEVER be opened while the Steam
Cleaner is in use, while there is steam and pressure in the Boiler or while
the Steam Cleaner is still hot. The Water Release Cap should only be
opened when the Steam Cleaner is completely cool.
NEVER HOLD THE STEAM CLEANER UNDER THE TAP TO FILL. Use the Filler
Funnel provided to fill the Water Tank.
The cleaning of the Boiler and Steamer is the sole responsibility of the
appliance owner. Calcium, mineral deposits and other sediments left to
build up in the Steam Cleaner causing it to fail and/or the steam pathways
in the Steam Cleaner to block, is not covered by the product warranty.
Users must follow the cleaning instructions above.
If the Steam Cleaner and Boiler is not cleaned according to the
instructions above and the product fails and/or the steam pathways are
blocked, the appliance owner should send the product for servicing by
contacting the Customer Support Line.
The Steam Cleaner is intended for domestic household use only. It is not
intended for commercial use. Any use other than for domestic household
purposes will void the product warranty.
10
Replacement of Brushes, Microfibre Pads
and Accessories
The Nylon and Brass Detail Brushes and the Microfibre Pad for the Small Brush and
Floor Brush provided with the Steam Cleaner are to get you started using your
Monster Steam Cleaner. As these brushes and microfibre pads become dirty or
wear out, replacement brushes and microfibre pads can be purchased from the
retailer from which you purchased your Steam Cleaner and/or from most other
electrical appliance retail outlets or visit www.monsterappliances.com.au.
It is normal to have replacements of the brushes and microfibre pads close at hand
when doing cleaning as the brushes wear out or the microfibre pads become dirty.
Any of the other accessory tools are replaceable by contacting the Monster
Customer Support Line. (See phone numbers on the back cover of this manual.)
11