12
Assembly
Quick installation guide_Conveyor system MB-flex Q N_20221114_EN.docx
3.2.2
Assembly the slide profiles on the modular belt conveyor
1. Fit the slide profiles (2) onto the top of the holding
profiles.
2. Check the slide profiles for damage.
ǃ
Only use undamaged slide profiles.
3. Chamfer the slide profiles at the start (viewed in
running direction).
4. Press the slide profiles in the running direction as
far as the stop.
ǃ
Avoid the development of “waves” in the slide
profiles by pressing it on completely.
5. Press the slide profiles at both ends onto the
chassis profile.
6. Press the slide profiles onto the holding profiles as
follows:
a) With straight holding profiles, press the slide
profiles onto the top side.
b) With bent holding profiles (in sliding bends),
press the slide profiles onto the top and bottom
side of the holding profiles.
7. Mount the slide profile seams with a gap of
approx. 2 mm and offset.
8. Cut the slide profiles at an angle in the running
direction.
9. Gently deburr the butt ends.
ǃ
Always mount the slide profiles over the seams
of the holding profile.
10. Cut the slide profile straight at the end of the holding
profile ( viewed in running direction) and press it on
flush.
11. Gently deburr the butt ends.
2