Assembly
11
Quick installation guide_Conveyor system MB-flex Q N_20221114_EN.docx
3.2.1
Assembly the chain guide profiles onto the bottom chassis profiles
1. Fit the chain guide profiles (1) onto the bottom of
the chassis profiles as shown.
2. Press the chain guide profile onto the chassis profile
in running direction as far as the stop with the bead
downwards (as shown).
ǃ
Avoid the development of “waves” in the chain
guide profiles by pressing it on completely
3. Check the chain guide profiles for damage.
ǃ
Only use undamaged chain guide profiles.
4. Chamfer the chain guide profiles at the start (viewed
in running direction).
5. Mount the chain guide profile seams with a gap of
approx. 2 mm and offset.
ǃ
Always mount the chain guide profiles over the
seams of the chassis profile.
6. Cut the chain guide profiles parallel in the running
direction.
7. Gently deburr the butt ends.
8. Each profile piece must be fixed at the beginning
(viewed in running direction).
9. Using the drill (drill bit ø 3.4 mm), drill a hole in the
chain guide profile and chassis profile.
10. Carefully knock in M4 x 8 plastic screw.
ǃ
Secure the chassis profile with a support against
bending!
11. Deburr after drilling.
12. Remove all chips.
13. Before intermediate elements or subsequent
elements, mount the chain guide profile flush with
the end of the chassis profile (viewed in running
direction).
14. At the end of the conveyor, mount the chain guide
profile flush with the drive.
Fig. 3: Assembly of the chain guide profiles onto the bottom chassis profiles
1
1