Assembly
13
Quick installation guide_Conveyor system MB-flex Q N_20221114_EN.docx
12. Each slide profile piece must be fixed at the
beginning (viewed in running direction).
13. Using the drill (drill bit ø 3.4 mm), drill a hole in the
slide profile and holding profile.
ǃ
Secure the profile with a support against
bending!
14. After drilling, deburr and remove all chips.
15. Carefully knock in M4 x 8 plastic screw.
ǃ
Secure the profile with a support against
bending!
16. With holding profiles where the conveyor chain lies
on (chain running surfaces), cut the screw head
carefully and flush.
17. Rework possible supernatants with the file.
18. With chassis profiles, also cut the screw head
carefully from below (chain running surface) and
flush.
19. Rework possible supernatants with the file.
20. Before intermediate elements or subsequent
elements, mount the slide profile flush with the end
of the holding profile (viewed in running direction).
21. At the end of the conveyor, mount the slide profile
flush with the drive.
Fig. 4: Assembly the slide profiles on the modular belt conveyor