Maintenance
16
Quick installation guide_Conveyor system EURO-flex Al_20221111_EN.docx
5
Maintenance
This chapter provides information on the maintenance work to be carried out:
▪
Lubrication (Page 16)
▪
Maintenance plan (Page 17)
▪
Maintenance log (Page 19)
▪
5.1
Lubrication
Incorrect or negligent use of hazardous substances may lead to serious environmental pollution.
Observe the following:
▪
Apply lubricant evenly and sparingly at the specified points.
▪
Carefully remove any escaping, used or excess lubricant.
▪
Deal with solvents and cleaning agents in accordance with the manufacturer's safety data
sheet.
▪
Dispose of all hazardous substances in accordance with the regional guidelines and
commission a specialist company if required.
Malfunctions and excessive levels of wear on individual components are likely to result from the use
of operating substances that cause significant pollution and/or that fail to comply with the stipulated
specification. Warranty claims that can be traced back to this content shall be rejected.
Observe the following:
▪
Use operating substances with the specified purity class.
▪
Check the state of the operating substance at regular intervals.
Lubrication schedule
No.
Designation
Name
Note
Interval [Bh]
Lubricant
1
Roller chain (Drive)
Spray!
Every time after cleaning!
170
Silicone spray
NSF H1
2
Drive station,
Deflection,
Sliding bend,
Bending wheel
Spray!
Every time after cleaning!
40
Silicone spray
NSF H1
3
Gear motor (Drive motor)
Details on lubrication and maintenance see manufacturer of the
gearmotor