12
Assembly
Quick installation guide_Conveyor system EURO-flex Al_20221111_EN.docx
Slide rail after the bending wheel:
11. Cut off the end of the slide rail with an angle of approx. 45°
with the mitre cutter.
12. Chamfer the slide rail end in the running direction.
ǃ
The slide rail must be slightly longer than the guide
profile.
ǃ
A distance of 2 mm must be maintained between the end
of the slide rail and the bending wheel.
ǃ
The end of the slide rail may not curve upwards or
downwards.
13. The slide rail must be double fixed at the start (viewed in the
running direction), see
“Fixing slide rail”.
Fixing slide rail:
14. Fasten each slide rail section at the front end (viewed in
running direction).
15. Using the drill (drill bit ø 3.4 mm), drill a hole in the slide rail
and chassis.
ǃ
Do not drill through slide rail. The underside of the slide
rail must not be drilled or protruding.
16. After drilling, deburr and remove all chips.
17. Carefully knock in M4 x 8 plastic screw.
18. Cut the screw head carefully and flush.
19. Rework possible supernatants with the file.
20. Mount the slide rail at the end of the profile (seen in the
running direction) before intermediate elements or following
elements with a spacing of approx. 5 mm.
21. Cut off the slide rail parallel to the elements with the mitre
cutter and gently deburr the ends.
22. Mount the slide rail at the end of the conveyor with a spacing
of approx. 5 mm at the drive station.
23. Cut off the slide rail parallel to the drive station with the mitre
cutter and gently deburr.
Fig. 2: Assembly the slide rails