www.euroboor.com
26
Once all 3 sides of the cutting plates are used, they need to be replaced. Use official EUROBOOR cutting
plates to ensure the same quality and endurance.
Replacing cutting plates:
1.
Undo mounting screw with the supplied L-type Torx wrench.
2.
Take of old cutting plate, put replacement piece in place.
3.
Fasten the mounting screw with the supplied L-type Torx wrench.
5.3 Replacing the impeller
The impeller contains 2 bearings which are subject to regular wear. A worn-out impeller results in a
roughly operating machine and an uneven bevel. It can be replaced as follows:
[image 4-3]
1.
Remove the milling head as described in paragraph: Changing or replacing the milling head.
2.
Clamp the milling head in a vice on the far outer rim.
3.
Undo the locking nut.
4.
Use a small pulley puller to pull the impeller with its bearings off the milling head.
5.
Gently tap the new impeller with bearings into place.
6.
Replace the locking nut and fasten it.
7.
Refit the milling head and other components as described in paragraph: Changing or
replacing the milling head.
Locking nut
Impeller
