BONUS FEET FOR SERGER
MODEL EP550 H
ELASTIC FOOT
This special sewing foot is for sewing on elastic tape. In the same operation, the fabric is trimmed, serged and gathered by
the constriction of the elastic tape.
Preparing the sewing machine
Differential feed setting:
set at “N” position
Stitch length:
4-5
Needles:
use 1 or 2 needles, depending on tape width
Thread tension:
standard setting
Inserting the elastic tape
•
Loosen screw (2) so that brake (1) at opening (4) is opened by 1.5 to 2 mm.
•
Place in elastic tape (3) and pass it back under the foot.
•
Tighten brake (1) with screw (2) again. The more screw (2)” is turned, the stronger
the pressure of the brake (1) is on the elastic tape and thus the greater the gather effect.
Note
:
When the sewing foot is raised, the elastic tape should be pulled through brake (1) slightly loosened.
BLIND HEM/LACE FOOT
One foot for both blind hem and lace sewing.
Blind Hem:
The hem is trimmed, serged and sewn in one operation.
Lace:
For sewing lace or borders together or onto a workpiece.
Preparing the sewing machine
Differential feed setting:
set at “N” position
Stitch length:
3 to 4
Thread tension:
standard setting
Needle:
remove the left needle and use
ONLY
the right needle
1.
Place the work under the foot. Fold the fabric and insert
it under the presser foot.
2.
How to sew:
a)
Turn the adjustment dial (1) to adjust the guide plate (2) to the left or right until the fold
of the fabric is in line with the needle.
b)
Sew the fabric so that the fold is always against the guide.
c)
Open out the fabric and press lightly on the wrong side.
EURO-PRO Operating LLC: Boston, MA, 02465
4400 Bois Franc, St. Laurent, Quebec
Tel. 1 (800) 361-4639
www.euro-pro.com
