10
09
Step 7
After installation is complete, you can turn the camera knobs on Floodlight
Camera to adjust the camera to your desired angle.
Step 8
Switch on the main circuit breaker in the house.
To check whether Floodlight Camera is operating, check if the LED indicator
has turned solid white.
In case Floodlight Camera is not powered on, switch off the
circuit breaker before checking the wiring of Floodlight Camera.
To avoid risk of shock, injury or death, always be cautious when
working with electricity. Remember, do hire a professional
electrician if you’re uncomfortable working with electrical wiring.
In case Floodlight Camera keeps blinking red, it means the
floodlight is not connected to the Internet. Please make sure the
Wi-Fi signal is strong at the desired location. You may consider
moving the wireless router closer to Floodlight Camera or using
a Wi-Fi range extender.
For troubleshooting, check the Help section in the Eeufy
Security app.
Refer to the app page for what the LED indicator status lights
mean.
Safety
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between
the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in
fixed/mobile exposure condition. The min separation distance is 20cm.
Notice:
Shielded cables
All connections to other computing devices must be made using shielded cables to maintain compliance
with FCC regulations.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004-5541
Telephone:1-206-383-8247
This product complies with the radio interference requirements of the European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.For the declaration of conformity,
visit the Web site www.eufylife.com
Due to the used enclosure material, the product shall only be connected to a USB Interface of version 2.0
or higher. The connection to so called power USB is prohibited.
The adapter shall be installed near the equipment and shall be easily accessible.
Do not use the Device in the environment at too high or too low temperature, never expose the Device
