EUCHNER MGBS-P-I-AP Series, Operating Instructions Manual, Page: 21 / 32

21
2527247-01-09/19 (Translation of the original operating instructions)
Operating Instructions
Safety System MGBS-P-I-AP…
EN
12. Setup
12.1. LED displays
You will find a detailed description of the signal functions in chapter 5. System status table on page 23.
LED Color
STATE green
DIA red
12.2. Teach-in function for handle module (only for unicode evaluation)
The handle module must be assigned to the interlocking module using a teach-in function before the system forms a func-
tional unit.
During a teach-in operation, the safety outputs are switched off, i.e. the system is in the safe state.
The teach-in operation is fully automatic. The number of possible teach-in operations is unlimited.
Tip!
Prior to switching on, close the guard on which the handle module to be taught in is installed. The
teach-in operation starts immediately after switching on. This feature simplifies above all teach-in with
series circuits and on large installations.
Important!
Ì The teach-in operation may be performed only if the device does not have any internal errors.
Ì Devices in the condition as supplied remain in the teach-in standby state until you have success-
fully taught in the first handle module. Once taught in, interlocking modules remain in the teach-in
standby state for approx. 3 min. after each switch-on.
Ì The interlocking module disables the code for the previous handle module if teach-in is carried out
for a new handle module. Teach-in is not possible again immediately for this device if a new teach-
in operation is carried out. The disabled code is released again in the interlocking module only
after a third code has been taught in.
Ì The interlocking module can only be operated with the last handle module taught.
Ì If, in the teach-in standby state, the interlocking module detects the handle module last taught in,
the teach-in standby state is ended immediately and the interlocking module changes to the nor-
mal state.
Ì The handle module to be taught in is not activated if it is within the operating distance for less than
30 s.
LED
STATE
DIA