EUCHNER MBM-PN MLI Series, Operating Instructions Manual

Page: 15 / 56

15
MAN20001572-01-07/22 (translation of the original operating instructions)
Operating Instructions Bus Module
MBM-PN-..-MLI-… (PROFINET)
EN
9. Controls and indicators
9.1. DIP switches
The DIP switches have the following functions:
Ì Setting the device’s PROFIsafe address
Ì Hardware reset to restore the device to the factory settings
Ì Activating the device web interface
A0 RST
OFF ON
1 2 3 4 5 6 7 8 9 10 11 12
ON CTS
Default: 000
00‘0000‘0000
WWW A1 A2 A3 A4 A5 A6 A7 A8 A9
Switch Description
A0 … A9
Address switch, bits zero to nine
For binary setting of the PROFIsafe address
(factory setting: 0000000000)
RST
Factory reset
(factory setting: off)
For information on the factory reset, see
chapter 13.3 on page 37.
WWW
Activate device web interface with extended
diagnostic options.
(factory setting: off)
For information on the device web interface,
see chapter 13.4 on page 38 .
9.2. LED displays
The LEDs indicate the device status and the communication status.
LED Description
Bus module MBM
LINK 1
Connection correct: statically On
PROFINET device localization: flashing
Color: green
ACT 1
Connection setup: flashing
Color: yellow
Connection setup complete, cyclical data traffic: statically On
Color: yellow
LINK 2
Connection correct: statically On
PROFINET device localization: flashing
Color: green
ACT 2
Connection setup: flashing
Color: yellow
Connection setup complete, cyclical data traffic: statically On
Color: yellow
SF
System fault:
statically On (see chapter 13. Diagnostics, troubleshooting and aids )
Color: red
BF
Bus fault:
statically On (see chapter 13. Diagnostics, troubleshooting and aids )
Color: red
DIA
Indicates errors
Color: red
US1
Power Up: flashing
Normal state: statically On
Color: green
MAINT
Indicates the error flashing code
Color: red/green/yellow
PS
Normal state: statically On
Device passivated: flashing
Control system communication error: flashing
Color: green