65
2504708-03-02/21 (translation of the original operating instructions)
Operating Instructions
Light Grids/Light Curtains LCA 2
EN
7.8. Mounting and aligning
Transmitters and receivers can be mounted using the mounting brackets included.
Figure 12: Mechanical mounting
The following points must be noted when mounting the system:
Mount the transmitter and receiver on a flat surface.
The optical surfaces must be exactly aligned with each other.
The transmitter and receiver must be installed at the same height. Use the LEDs for the correct alignment of transmitter
and receiver. If the alignment is correct, the LED on the receiver illuminates green continuously.
Pay attention to the maximum tightening torque for mounting the mounting brackets of 5 to 6
Nm.
Pay attention to the maximum tightening torque for mounting the transmitter and receiver on the mounting bracket of
2.5 to 3
Nm.
Use only accessories from EUCHNER for mounting.
DANGER
Disabling of the safety function
The protective function of the system can be disabled if the system is mounted incorrectly.
Always mount transmitters and receivers while observing the minimum distance S.
Make sure that reaching over, reaching under, going around, walking behind, as well as moving
the system are excluded.
Make sure that the danger zone is adequately protected by the system’s protective field.
NOTICE
Risk of damage to equipment and malfunctions as a result of incorrect installation
Make sure that the components are not damaged while mounting the system.
Pay attention to the maximum tightening torque.
Summary of Contents for LCA 2 Series
Page 44: ......
Page 45: ...EN Operating Instructions Light Grids Light Curtains LCA 2 ...
