EUCHNER 163293, Operating Instructions Manual

Page: 15 / 64

15
2540772-01-11/21 (translation of the original operating instructions)
Operating Instructions Bus Module
MBM-EC-..-MLI-… (EtherCAT)
EN
9. Controls and indicators
9.1. DIP switches
These DIP switches have the following functions:
Ì Setting the device’s FSoE slave address
Ì Hardware reset to restore the device to the factory settings
Ì Activating the device web interface
A0 RST
OFF ON
1 2 3 4 5 6 7 8 9 10 11 12
ON CTS
Default: 000
00‘0000‘0000
WWW A1 A2 A3 A4 A5 A6 A7 A8 A9
Switch Description
A0 … A9
Address switch, bits zero to nine
For binary setting of the FSoE address
(factory setting: 0000000000)
RST
Factory reset
(factory setting: off)
For information on the factory reset, see
chapter 13.3 on page 43.
WWW
Activate device web interface with extended
diagnostic options.
(factory setting: off)
For information on the device web interface,
see chapter 13.4 on page 44 .
9.2. LED displays
The LEDs indicate the device status and the communication status.
LED Description
Bus module MBM
L/A IN
Connection correct: statically On
Data transfer: flashing at 10 Hz
Color: green
EC STAT
Normal state: statically On
Flashing codes according to EtherCAT specification
Color: green/red
L/A OUT
Connection correct: statically On
Data transfer: flashing at 10 Hz
Color: green
FSoE
Normal state: statically On
Color: green
FSoE inactive/passivated: statically On
Color: yellow
FSoE Reset/Init State: flashing
Color: yellow
FSoE error: statically On
Color: red
FSoE – no connection to control system: Off
DIA
Indicates errors
Color: red
MAINT
Indicates the error flashing code
Color: red/green/yellow
SF
System fault:
statically On (see chapter 13. Diagnostics, troubleshooting and aids )
Color: red
Power
Power Up: flashing at 5 Hz
Normal state: statically On
Color: green