www.etsnord.com
6
®
RDM-31-0322
NORD
canopy
|
OZ 3.1 Installation Guide
4. Installation
4.1 General information
Ozone is drawn into the grease chamber through the ozone duct, which is located on the ceiling of the canopy.
The ducting and bends necessary for connection are included with the canopy.
Always install the ozone ducting according to the manufacturer’s drawings.
The ozone duct must be made of acid-resistant stainless steel (AISI 316).
Before starting the Ozone Module, check visually that all ozone duct connections are airtight.
Always leave a minimum of 500mm free space in front of a canopy to allow access for maintenance.
If the kitchen has already been operational before installation of any Ozone Modules, the exhaust ducts should
be thoroughly cleaned from grease and soot to achieve the best results.
Width of service area
min 500 mm
Never drill or screw into the Ozone Module chassis.
