Images are for illustrative purposes.
We reserve the right to make changes.
3
®
RDM-31-0322
NORD
canopy
|
OZ 3.1 Installation Guide
Safety notes
• This manual consists of important information on the instruction and safety of the Ozone Cleaning System.
Read this manual carefully before installing, commissioning or performing maintenance or repair work on
the system.
• Always wear appropriate protective clothing when handling the equipment.
• The Ozone Cleaning System is intended only for the treatment of exhaust air as described in these instructions.
• The Ozone Cleaning System uses high voltage to create an electric charge that generates ozone (O
3
). Ozone
significantly reduces odor, grease, mold and bacteria. ETS NORD AS disclaims any liability in the case
that the product is not used in accordance with the manufacturer’s instructions contained in this manual.
Installation flowchart
For ease of installation and service, it is suggested the installing contractor have the following tools on hand:
• Narrow 2mm flat-head screwdriver
• #1 Phillips screwdriver
• T4 screwdriver
• Small flashlight
• Electrical fish tape
• Silicone and silicone gun
Install ozone
module to
the supply air
chamber
Mount Control
Panel
Perform electrical
installation of the
system
Connect supply
mains for control
panel and ozone
modules
Connect data
wiring for all
ozone modules
Check the product
shipment
Set unique device
addresses and
apply sequential
number stickers
Connect two
pressure
measurement
tubes
