19
PREP
ARING FOR OPERA
TION
SETUP
SETUP
Page 1
Twelve (12) parameters are adjustable in Page 1 of the Setup screen. Tapping the parameter name it its header
will show a pop-up window describing that parameter. Exit by tapping anywhere on the pop-up window or the “X”.
• Pump Threshold
o Minimum required current for the asphalt pump to turn. Setting this too high may
prevent the pump from stopping. Setting this too low will prevent the pump from
being properly controlled at low speeds.
o
Default: 400 milliamps (Rexroth), 15 milliamps (Danfoss)
• Minimum Flow
o Minimum pump flow rate in Bar Circulate and Spray modes. When all one-foot
switches are off, this is not used, and the flow rate goes to zero.
o Default: 5 gallons per minute
• Spray Delay ON
o Amount of time after turning the Master Spray Switch ON that the spray valves will
open. This allows time for the four way valve to turn before opening the spray bar.
o Default: 0.00 seconds
• Spray Delay OFF
o Amount of time after turning the Master Spray Switch OFF that the spray valves
will close. This allows time for the four way valve to turn before closing the spray bar.
o Default: 0.20 seconds
Figure 13 - Page 1 of Setup Screen
Figure 14 - Pump Threshold Description
Setup
