BGA ETA-H15 OPERATION MANUAL
Page6
7. control box Instructions
IR
system Key
A.
During selecting working flow period,
UP and DOWN
knob
are used for controlling the moving
upward or downward of cursor but when in standby interface, it can increase or decrease the digital.
During the soldering or de-soldering period, also top IR heater haven’t started to heat up,
knob
UP and
DOWN are used for controlling movement upward or downward of top IR heater. That is to say, during
movement upward and downward of top IR heater, after pressing the key start, UP and DOWN knob make
the top heater stop at a proper position.
B.
Under the standby condition, if the cooling fan have already drawn back, press
UP
and DOWN knob to
make the top IR heater move up and down.
C.
Function of OK key: Make the BGA-IR enter parameters setting mode and cursor move a step forward.
D.
Function of “cool/stop” key: if BGA-IR in flow, stop and finish flow; if BGA-IR in flow, open or close
cool fan.
E.
Function of “START” key: in standby state, make BGA-IR enter solder and desolder.
F.
Function of “in-out/suck” key: cool fan stretch out or retraction.
PL system Key
G.
Function of “Z” key: rotate it, can realize suck mouth movable.
H.
Function of “R” key: rotate it, can realize clockwise or anticlockwise rotate, rotate degree have no limit.
I.
Function of “ZOOM/IN-OUT” key: rotate it, adjust magnify ratio of picture, press it, control aligning
prism pass in and out.
J.
Function of “FOCUS/SUCK” key: rotate it, realize focus; press it, suck chip.
K.
Function of “BLUE” key: rotate it, adjust blue light of camera; press it, close the light.
Connect USB line
Connect video line
Connect control box
Connect ground line
Summary of Contents for BGA ETA-H15
Page 2: ......
