Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the points
in the following table.
Cause or remedy:
Problem:
Appliance is connected
to the power mains but it
does not work.
•
Make sure there is voltage in the power outlet and that the appliance
is switched on.
Appliance cools
continuously for a long
time.
•
The compressor is operating for a longer time at low capacity (low
energy consumption / high efficiency). This is the most efficient form
of operation. The following factors can also influence the appliance’s
operation:
-
The ambient temperature is too high.
-
The door has been opened for too long or too frequently.
-
The door is not closed properly.
-
The door does not seal properly (the seal is dirty, the door is
misaligned or the seal is damaged, etc.).
-
Too much fresh food has been put in at the same time.
-
The sensor in the refrigerator is blocked by fresh food. Make
sure that air can circulate freely around the sensor (not applicable
to all models).
Excessive ice formation
in the freezer.
•
The door has been opened for too long or too frequently.
•
The door is not closed properly.
•
The door does not seal properly (the seal is dirty, the door is
misaligned or the seal is damaged, etc.).
•
Manually defrost the appliance.
Condensation on the
glass shelf above the
drawers in the
refrigeration
compartment.
•
Check that the door is closed properly and seals properly.
•
This is a temporary problem that cannot be avoided entirely in periods
of high ambient temperatures and high humidity. The problem
disappears when the temperature and humidity return to normal
levels. We recommend that you clean the drawers more frequently
and occasionally wipe off any drips.
•
Pack food in bags or other air-tight packaging.
•
Open the humidity control slider.
The light above the set
temperature display will
flash:
•
The door has been opened for too long or too frequently.
•
The door does not seal properly (the seal is dirty, the door is
misaligned or the seal is damaged, etc.).
•
An extended power failure.
•
Too much fresh food has been put in at the same time.
30
Summary of Contents for KVV793 Series
