18
© ETNA Coffee Equipment b.v.
Instruction for use Dorado Medium Espresso
C O F F E E T E C H N O L O G I E S
3.2
Filling containers
The containers contain the ingredients for preparing the drinks. There
are 2 ways of filling these containers:
•
by opening the top lid and filling the container in the machine;
•
by filling the container outside of the machine.
3.2.1 Filling the container in the machine
1. Open the door of the machine.
2. Open the lid on the container that needs refilling. Refill the container
with the correct ingredients.
3. Close the upper lid.
4. If the container was completely empty, the supply will need refilling.
•
Hold the container above the waste bucket. Turn the spindle of
the container until the ingredient runs out of it.
3.2.2 Filling the ingredient containers outside the machine
The containers hold the ingredients required to prepare drinks.
Ensure that no fingers are trapped when filling the
containers.
☞
Make sure that the right ingredient is put in the correct
container.
➭
See the label on the inside of the door for an overview of
the maintenance functions.
1. Open the door of the machine.
2. Open the upper lid.
3. Closes the container spout, by pushing the button until it clicks. (zie
figuur 0-1)
4. Lift the containers being filled out of the holder and pull them
towards you.
5. Fill the container with the required ingredient.
6. Replace the container in the machine in its original position. Ensure
that the coupling of the container latches onto the gear.
7. Open the container by pushing the cover down until it clicks open.
(zie figuur 0-2)
8. Repeat this procedure for the other ingredients containers.
9. Close the cover.
10.Place a 1.5 l cup under the dispensing spout.
11.Press button *00* on the service panel; clean valves = rinse mixers.
The valves will be rinsed with water. Repeat if necessary (if
applicable).
12.Close the door of the machine.
Figure 3-1
A
B
