ETIC 1220, User Manual, Page: 28 / 64

HTML SET UP & DIAGNOSTIC
Page 28 User’s guide ref 9014709-02 XSLAN SHDSL switch
3.3
Modifying the configuration from the LAN
Step 1 :
Ensure the DIP switch SW1 and SW2 are OFF to select the
stored IP @.
Step 2 :
Launch the html browser and enter the IP address assigned to
the router.
Or, launch the ETICFINDER utility to detect the XSLAN IP address.
Remark :
If the home page cannot be displayed, refer below.
4 Rebooting the XSLAN after parameters changes
•
After the parameters any page have been completed, click the
« Save » button at the bottom of the page.
•
After some parameters changes, the IPL-E must restart.
When the configuration has been completely carried out, click the
«
Reboot » red button in the green bar, when displayed.
•
Once the product has restarted, check the « Reboot » button has
disappeared from the green bar.
T
o save the configuration file to a hard disk :
•
Select the “maintenance” menu and then the “Save / restore” menu.
•
Click the “Save current configuration to disk” button.
5 Recovering the factory LAN IP address
When launching the html browser, the homepage of the html server may
not be displayed; the cause may be the IP address you entered was
wrong.
if the IP address you enter is wrong,
you can recover the factory IP
address by setting SW01 ON and SW2 OFF.
The factory IP address 192.168.0.128 will be restored as long as the
SW01 and SW02 micro switch will be left in that position.