ANNEX 1
DOC_DEV_XS_Setup guide_C
page 79
Numeric OIDs
Replace “ifindex” with the SHDSL interface index in the table below.
hdsl2ShdslEndpointCurrAtn
.1.3.6.1.2.1.10.48.1.5.1.1.ifindex.0.1.1
hdsl2ShdslEndpointCurrSnrMgn
.1.3.6.1.2.1.10.48.1.5.1.2.ifindex.0.1.1
hdsl2ShdslEndpointCurrStatus
.1.3.6.1.2.1.10.48.1.5.1.3.ifindex.0.1.1
hdsl2ShdslEndpointES
.1.3.6.1.2.1.10.48.1.5.1.4.ifindex.0.1.1
hdsl2ShdslEndpointSES
.1.3.6.1.2.1.10.48.1.5.1.5.ifindex.0.1.1
hdsl2ShdslEndpointCRCanomalies
.1.3.6.1.2.1.10.48.1.5.1.6.ifindex.0.1.1
hdsl2ShdslEndpointLOSWS
.1.3.6.1.2.1.10.48.1.5.1.7.ifindex.0.1.1
hdsl2ShdslEndpointUAS
.1.3.6.1.2.1.10.48.1.5.1.8.ifindex.0.1.1
3.3.2
Table HDSL2-SHDSL-LINE-MIB::SpanStatusTable
•
OID hdsl2ShdslStatusActualLineRate (.1.3.6.1.2.1.10.48.1.2.1.3.ifindex) : data rate of the SHDSL line.
It is recommended to monitor this OID, if the chosen profile for the line is not a fixed datarate profile.
The other fields are not supported and are set to 0.
3.3.3
Table HDSL2-SHDSL-LINE-MIB::SpanConfProfileTable
This table gives the list of the profiles defined for the SHDSL links configuration.
These informations are the same as the ones in the web page « SHDSL ports »
3.3.4
Table HDSL2-SHDSL-LINE-MIB::SpanConfTable
This table gives the SHDSL profile associated with each SHDSL port.
3.4
MIB : BRIDGE-MIB::dot1dBridge
Information about the Ethernet bridge are gathered under this OID. This MIB is published by the IETF under
RFC4188.
3.4.1
OID BRIDGE-MIB::dot1dBase
The following information is displayed :
•
OID BRIDGE-MIB::dot1dBaseBridgeAddress : Bridge MAC address
•
OID BRIDGE-MIB::dot1dBaseNumPorts : Number of ports in the bridge
•
OID BRIDGE-MIB::dot1dBaseType : Type of bridge (Tranparent-only)
Summary of Contents for XLAN+ Series
Page 6: ......
Page 49: ...SETUP DOC_DEV_XS_Setup guide_C page 49 ...
Page 74: ......
Page 82: ......