Etic Telecom RAS Series, Setup Manual

Page: 51 / 74

SETUP
DOC_DEV_Router setup guide_A
page 51
13 M2Me_Connect connection setup
That paragraph applies to all the models of RAS Routers. It also applies to all other Routers, only if the M2Me
option has been enabled.
Preliminary remark :
To provide access to a machine for remote users through the M2Me_Connect service, it is necessary to
carry-out three steps :
1
st step : carry-out the M2Me connection set-up described in this paragraph.
2 nd step : Register a remote user (at least) in the user list; refer to a further paragraph in the manual.
3 rd step : Assign access rights for the remote users.
The M2Me_Connect OpenVPN connection is set from the Router to the M2Me_Connect server.
The VPN can be transported in UDP or TCP.
•
Select the Set-up > Remote access > M2Me_Connect menu.
« TCP port » & « UDP ports » parameters :
Enter the selected UDP and TCP ports the Router will have to test to set the M2Me VPN.
The Router will try to set the M2Me connection successively with the selected UDP and TCP ports beginning
with UDP.
• If a proxy server filters outgoing connections, unselect the No Proxy checkbox and enter the Proxy server
parameters :
the type of the proxy server (HTTP, SOCKS5)
the proxy IP address and port number
the type of required authentication (None, basic, NTLM) if the proxy is http
Once the M2Me connection has been set-up, the M2Me led flashes.
Attention :
Do not forget to copy the product key of the Router (ABOUT menu); it is required by the M2Me software of
the remote PC when you will set-up the connection to the Router.