SETUP
DOC_DEV_Router setup guide_A
page 37
7.4
Setting up an outgoing connection
An outgoing connection is a connection initiated by the current Router.
•
Select the « Add » button located just below the Outgoing connection table.
•
Select the « Enable » option and assign a name to the connection.
“Login
& Password” parameter:
Enter the login and password, the router will have to use to authenticate.
Remark : That login & password must be registered in the ingoing connection.
« VPN server IP address» parameter :
Enter the IP address of the VPN server.
That address can be a public IP address or a domain name or a DynDNS or NoIP address.
« Backup VPN server IP address» parameter :
The client VPN Router is able to set a backup VPN if the main VPN fails.
“Port number” & “protocol” parameters :
Select the port Nr and the type of level 3 protocol used to transport OpenVPN.
Attention : The port number value must be different from the one used by remote users.
“Encryption algorithm” & “Authentication algorithm” parameter :
AES provides a better encryption than 3DES, and SHA-1 a better authentication than MD5.
«Attach the VPN to a specific interface» list :
An outgoing OpenVPN connection is normally attached to the main WAN interface of a Router, for instance
the cellular interface in the case of cellular router like IPL-C or RAS-EC.
However, it can be useful to attach the VPN to one other interface of the Router.
Select the interface to which the VPN must be attached.
Summary of Contents for RAS Series
Page 1: ...DOC_DEV_Router setup guide_A RAS IPL SIG _________________ SETUP GUIDE _________________ ...
Page 8: ......
Page 14: ......